Uranium–lead dating - Wikipedia
For example, at the stage when about 50 percent of the magma has solidified .. U-Pb dating attempts to get around the lack of information about initial daughter. INTRODUCTION RADIOMETRIC DATING HALF LIFE . for half the nuclei in a sample of a radioactive substance to undergo radioactive decay. Common isotopes used in age dating U-Pb -- half-life of U is b.y. developed radioactive dating. → absolute Most common systems for dating geological samples e.g. radiogenic Pb deposited with U by hydrothermal fluids.
As the mineral cools, the crystal structure begins to form and diffusion of isotopes is less easy. At a certain temperature, the crystal structure has formed sufficiently to prevent diffusion of isotopes. This temperature is what is known as closure temperature and represents the temperature below which the mineral is a closed system to isotopes.
Thus an igneous or metamorphic rock or melt, which is slowly cooling, does not begin to exhibit measurable radioactive decay until it cools below the closure temperature.
The age that can be calculated by radiometric dating is thus the time at which the rock or mineral cooled to closure temperature. This field is known as thermochronology or thermochronometry. The age is calculated from the slope of the isochron line and the original composition from the intercept of the isochron with the y-axis. The equation is most conveniently expressed in terms of the measured quantity N t rather than the constant initial value No.
The above equation makes use of information on the composition of parent and daughter isotopes at the time the material being tested cooled below its closure temperature. This is well-established for most isotopic systems. Plotting an isochron is used to solve the age equation graphically and calculate the age of the sample and the original composition.
Modern dating methods[ edit ] Radiometric dating has been carried out since when it was invented by Ernest Rutherford as a method by which one might determine the age of the Earth. In the century since then the techniques have been greatly improved and expanded. The mass spectrometer was invented in the s and began to be used in radiometric dating in the s.
It operates by generating a beam of ionized atoms from the sample under test. The ions then travel through a magnetic field, which diverts them into different sampling sensors, known as " Faraday cups ", depending on their mass and level of ionization. On impact in the cups, the ions set up a very weak current that can be measured to determine the rate of impacts and the relative concentrations of different atoms in the beams.
Uranium—lead dating method[ edit ] Main article: Uranium—lead dating A concordia diagram as used in uranium—lead datingwith data from the Pfunze BeltZimbabwe. This scheme has been refined to the point that the error margin in dates of rocks can be as low as less than two million years in two-and-a-half billion years.
Zircon has a very high closure temperature, is resistant to mechanical weathering and is very chemically inert. Zircon also forms multiple crystal layers during metamorphic events, which each may record an isotopic age of the event.
This can be seen in the concordia diagram, where the samples plot along an errorchron straight line which intersects the concordia curve at the age of the sample.
Historical Geology/U-Pb, Pb-Pb, and fission track dating - Wikibooks, open books for an open world
Samarium—neodymium dating method[ edit ] Main article: Samarium—neodymium dating This involves the alpha decay of Sm to Nd with a half-life of 1. Accuracy levels of within twenty million years in ages of two-and-a-half billion years are achievable. Potassium—argon dating This involves electron capture or positron decay of potassium to argon Potassium has a half-life of 1. Rubidium—strontium dating method[ edit ] Main article: Rubidium—strontium dating This is based on the beta decay of rubidium to strontiumwith a half-life of 50 billion years.
This scheme is used to date old igneous and metamorphic rocksand has also been used to date lunar samples. Closure temperatures are so high that they are not a concern. Rubidium-strontium dating is not as precise as the uranium-lead method, with errors of 30 to 50 million years for a 3-billion-year-old sample. Uranium—thorium dating method[ edit ] Main article: Uranium—thorium dating A relatively short-range dating technique is based on the decay of uranium into thorium, a substance with a half-life of about 80, years.
It is accompanied by a sister process, in which uranium decays into protactinium, which has a half-life of 32, years. While uranium is water-soluble, thorium and protactinium are not, and so they are selectively precipitated into ocean-floor sedimentsfrom which their ratios are measured. The scheme has a range of several hundred thousand years.
A related method is ionium—thorium datingwhich measures the ratio of ionium thorium to thorium in ocean sediment. Radiocarbon dating method[ edit ] Main article: Carbon is a radioactive isotope of carbon, with a half-life of 5, years,   which is very short compared with the above isotopes and decays into nitrogen. Carbon, though, is continuously created through collisions of neutrons generated by cosmic rays with nitrogen in the upper atmosphere and thus remains at a near-constant level on Earth.
The carbon ends up as a trace component in atmospheric carbon dioxide CO2. A carbon-based life form acquires carbon during its lifetime. Plants acquire it through photosynthesisand animals acquire it from consumption of plants and other animals. When an organism dies, it ceases to take in new carbon, and the existing isotope decays with a characteristic half-life years. The proportion of carbon left when the remains of the organism are examined provides an indication of the time elapsed since its death.
This makes carbon an ideal dating method to date the age of bones or the remains of an organism. The carbon dating limit lies around 58, to 62, years.
However, local eruptions of volcanoes or other events that give off large amounts of carbon dioxide can reduce local concentrations of carbon and give inaccurate dates. The releases of carbon dioxide into the biosphere as a consequence of industrialization have also depressed the proportion of carbon by a few percent; conversely, the amount of carbon was increased by above-ground nuclear bomb tests that were conducted into the early s.
Also, an increase in the solar wind or the Earth's magnetic field above the current value would depress the amount of carbon created in the atmosphere.Radiometric Dating
Fission track dating method[ edit ] Main article: This involves inspection of a polished slice of a material to determine the density of "track" markings left in it by the spontaneous fission of uranium impurities.
Some of the problems associated with K-Ar dating are Excess argon. This is only a problem when dating very young rocks or in dating whole rocks instead of mineral separates. Minerals should not contain any excess Ar because Ar should not enter the crystal structure of a mineral when it crystallizes. Thus, it always better to date minerals that have high K contents, such as sanidine or biotite.
Historical Geology/U-Pb, Pb-Pb, and fission track dating
If these are not present, Plagioclase or hornblende. If none of these are present, then the only alternative is to date whole rocks. Some 40Ar could be absorbed onto the sample surface.
This can be corrected for. Most minerals will lose Ar on heating above oC - thus metamorphism can cause a loss of Ar or a partial loss of Ar which will reset the atomic clock.
If only partial loss of Ar occurs then the age determined will be in between the age of crystallization and the age of metamorphism.
If complete loss of Ar occurs during metamorphism, then the date is that of the metamorphic event. The problem is that there is no way of knowing whether or not partial or complete loss of Ar has occurred.
Thus the ratio of 14C to 14N in the Earth's atmosphere is constant. Living organisms continually exchange Carbon and Nitrogen with the atmosphere by breathing, feeding, and photosynthesis. When an organism dies, the 14C decays back to 14N, with a half-life of 5, years. Measuring the amount of 14C in this dead material thus enables the determination of the time elapsed since the organism died. Radiocarbon dates are obtained from such things as bones, teeth, charcoal, fossilized wood, and shells.
Because of the short half-life of 14C, it is only used to date materials younger than about 70, years. Other Uses of Isotopes Radioactivity is an important heat source in the Earth. Elements like K, U, Th, and Rb occur in quantities large enough to release a substantial amount of heat through radioactive decay. Thus radioactive isotopes have potential as fuel for such processes as mountain building, convection in the mantle to drive plate tectonics, and convection in the core to produce the Earth's magnetic Field.